Instructions for the use of plastering machines
1. There is no need to punch or rebar before use. As long as the wall is shaded one day in advance, the shade is the best, and the wall that does not absorb water should not be shaded, (e.g. cement wall).
2. When in use, as long as the track matched in the factory is matched with the length of the wall root, it can be constructed.
3. Before leaving the factory, the machine flour board surface has been adjusted and fixed, so it should not be adjusted without error.
4. Fix the machine in the middle room and run it empty once.
5. Pull out the pedal at the bottom of the back of the chassis, step on the pedal, pull the cable-stayed tube of the distribution board by hand. If you can easily pull the front half of the machine, you can, if it is too heavy, roll the tire forward until you can easily pull the front half of the body. If you pass through www.huafenchimoju.cn www.mingheertui.com www.luyanshimoju.net.cn www.helesuliao.com www.shidiao820.com www.weishengzhiji.cnthe low door hole, the tire will roll back, and the machine can pull sideways.
6. The forebody of the machine can be easily raised. Place the bottom iron wheel on the track, then start with the upright column, stop when it reaches the top 1-2 cm, start the smoothness digital display, turn on the push rod motor and stop when it sees the digital display 90 C, so as to ensure that the wall is vertical and flat without error.
7. Fill the ash bucket and the powder mouth. Pay attention to the prohibition of ash filling around the two pillars. The amount of ash filling depends on the height of the room and the thickness of the powder wall. Generally, a bucket of ash with a height of 3 meters and a thickness of 2 centimeters is enough, and there is no need to add ash in the middle.
8. The button-up switch is the powder plate vibration for two seconds, the time can be adjusted, and then rise. When the hopper vibration starts at about one meter, the time can be adjusted. When the top hopper vibration stops, the powder plate vibration stops for one to two seconds, then the manual control stops, and the button-up switch goes down. This cycle only takes 2-3 minutes.