新闻动态
新闻动态 当前位置:首页>新闻动态>新闻动态

粉墙机器操作步骤

网址:www.fenqiangjixie.cn  2019-08-09  作者:admin    阅读:

粉墙机器操作步骤
Powder Wall Machine Operating Steps
墙面打点(中部点距地面 1.6m,底部点距地面400px,每隔1.5m打一个点) ,提前一天做。
Wall dotting (1.6 m from the middle point to the ground, 400 PX from the bottom point to the ground, one dot every 1.5 m), one day in advance.
墙面浇水(砖墙)。提前一天做
Wall watering (brick wall). Do it one day in advance
量房间高度,加合适的接头。(机器里的立杆是抹2.85米房高的,如果房间高就要加相应该的接头)
Measure the height of the room and add suitable joints. (The upright pole in the machine is 2.85 meters high, if the room is high, the corresponding connection should be added.)
安装立杆。(两个人安装,确保丝扣链接处平整)
Install the pole. (Installation by two persons to ensure the level of the screw link)
安装拉手。(拉手分左右)
Install handle. (Hand in Hand)
接上电源,如果电源指示灯一直亮,说明三相电源是正确,如果灯亮一下就熄了,电源输入反了
Connect the power supply, if the power indicator lights up all the time, it means that the three-phase power supply is correct, if the light turns on, it will go out, and the power input is reversed.
点向上按钮,使机器立杆上升距天花1-50px
Point up the button to make the machine pole rise 1-50px from the ceiling
锁紧液压,拉起拉手
Lock up the hydraulic pressure and pull up the handle
定位(一人扶中杠,另一人拿支子并踩液压)
Positioning (one holds the middle bar, the other holds the support and treads on the hydraulic pressure)
踩液压,立杆上升并顶紧天花板,机器固定。
Step on the hydraulic pressure, the pole rises and tightens the ceiling, and the machine is fixed.
加灰,点启动键机器上升
Ashing, Point Start Key Machine Rising
机器到顶后,振动5-7秒,关闭电源,再开启电源,机器下降并压光墙面。
When the machine reaches the top, it vibrates for 5-7 seconds. Turn off the power and turn on the power. The machine descends and calenders the wall.
机器到底部后,松液压
After the bottom of the machine, loosen the hydraulic pressure
点下降按钮(下降50px既可),立杆下降。
Point down the button (50 PX down) and the pole down.
移动机器(使机器抹板紧贴墙面并平移机器),使两板墙之间有50px的距离相接。
Mobile machine (make the machine wiper close to the wall and move the machine), so that the distance between the two walls is 50px.

转让电话
13313028229